0

Out of 0 Ratings

Owner's of the Roland Stereo Amplifier KC-550 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 16
 
12
Connect your KC-550/KC-350
Stereo Link
Stereo playback is enabled simply by connecting two KC-550 or KC-350 units with a single audio cable (phone type).
This function is called “Stereo Link.” As the channel control section is designed to accept stereo signals, connection of sound
sources is needed only at the main unit, thus enabling channel volumes to be centrally controlled on the main unit.
The right-channel signals are output from the speakers in the main unit, while the left-channel signals are output from the
speakers in the sub unit (the other KC-550/KC-350).
fig.30-2
Connections
When using a Stereo Link configuration, connect all peripheral
equipment to the main unit. Do not connect to any input/
output jacks on the sub unit other than
STEREO LINK IN
.
* Before making the connections, be sure that the volume setting
of the VOLUME knob for both amplifiers is set to “0.”
Switching the power on or off
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Turn on the devices connected to CH 1 through CH 4.
2. Turn on the main KC-550/KC-350 amplifier.
3. Turn on the sub KC-550/KC-350 amplifier.
4. Turn on the devices connected to LINE OUT or
SUBWOOFER OUT.
5. Adjust the volume levels on all devices.
Before switching off the power, lower the volume on each of
the devices in your system, then TURN OFF the devices in
the reverse order of that used when switching them on.
About the Volume and Tone Settings
Adjust the Main (R) and Sub (L) volume levels separately
using their VOLUME knobs.
* You can make each unit's equalizer (LOW, MIDDLE and HIGH
knobs), SHAPE switch, VOLUME knob, and MAIN (R) and
SUB (L) settings independently.
Basically, they should be set to the same positions, but you can
adjust each one as necessary to suit the needs of a particular
setup.
OUT
IN
Keyboard
Sub (L-channel signals)
Main (R-channel signals)